This article provides pairing and installation instructions for the Occupancy Sensor.
The occupancy sensor is a passive, infrared motion sensor with a built-in temperature sensor and light illumination sensor. It will detect movement and the temperature of the room. The sensor can be configured as either a security sensor, which activates the alarm when triggered, or an occupancy/vacancy sensor, which controls home automation or lighting functions via the system automation controls. Both the temperature and light illumination sensor can also be used to trigger home automation devices.
The motion sensor has a sleep timer of 30 seconds to conserve power. After detecting movement, the sensor will not re-transmit a detection signal for the next 30 seconds. After 30 seconds, the sensor will return to normal operation and begin transmitting a detection signal again. This way continuous movement in front of a PIR will not unduly exhaust the battery. A signal detecting room temperature is sent every 10 minutes.
Follow these steps to pair your Occupancy Sensor:
- Remove the sensor and battery from the box.
- In the abode web app, navigate to the Devices page, and then click on the “+”.
- In the Add Device dialog, select the Other Devices tab. Your Gateway is now ready to pair your device.
- Remove the base from the sensor by holding the sensor in one hand with the base pointed down, then twist the base counter clockwise to release, and remove it to gain access to the battery compartment. Remove the back cover of the sensor by turning it clockwise and then pulling.
- Insert the battery.
- Press and hold the Function button on the inside of the sensor for approximately 15 seconds.
- The device will show up in your device list, select Add next to the device and then follow the wizard to complete the pairing process.
- Reassemble the sensor.
- That’s it! The Occupancy Sensor is now paired with your abode system.
If pairing is unsuccessful, remove battery from device then press the function button 3 times to bleed off voltage from the circuit, then reinsert battery and repeat the pairing process.
The sensor can sit on a flat surface or be mounted on the wall. The base of the sensor has two mounting holes used for installation on a surface with fixing screws and plugs provided. The bracket is adjustable to provide the aiming of the sensor in an upward or downward position. When mounting on a wall, it is recommend to mount it 6 feet to 7 feet from the floor looking down at an angle. The motion sensor has a detection coverage of a 120° to the maximum range of about 34 feet.
The LED indicator is located at the center of the IR lens and does not light up when operating. If the LED starts flashing when it has detected a movement, it may have a low battery or its tamper has been triggered.
When using the device for security, place it in a position such that an intruder would normally move across the motion sensor’s field of view and be sure it will not be obstructed by curtains, hanging ornaments, etc. Do not install the motion sensor at direct sunlight or close to heating/cooling appliances and vents. Do not point the motion sensor at heat source such as heater, radiator, or windows. It is important to avoid location where pets are located as the motion sensor is not pet immune, and they will trigger this sensor.
When using the mounting holes on the sensor’s base, drill holes in the surface. Insert the wall plugs if fixing it into plaster or brick. Screw the base into the wall plugs then loosen the angle adjustment screws and tilt the sensor until you are satisfied with the detection angle. Tighten the screws to lock the sensor into place.
Replacing the Battery
The sensor uses one CR123A 3V Lithium battery. To replace battery, the sensors main body must be removed from base to access battery compartment. Remove the base from the sensor by holding the sensor in one hand with the base pointed down then twist the base counter clockwise to release, and remove it to gain access to the battery compartment. Remove the back cover of the sensor by turning it clockwise and then pulling.
The battery compartment has a strip which should be pressed under the battery when battery is inserted. When removing battery, simply lift the strip. Press the function button on the inside of the sensor twice to fully discharge before inserting new battery.